Quick Start

Here are the steps to start working with the oscilloscope:

• On the device please make sure that the little black "~/-" switch for channel A set to the position "-"
• Open the Oscilloscope application and select the Oscilloscope tab
• Set the Channel A knob (red) to the position 5V and the button below is "On"
• Connect an AA battery to the channel A probe (+ and the ground don't matter) and press Cyclic button
• You should see a signal on the screen.

To start working with the Logic Analyzer and Generator do the following:

• Carefully remove the plastic holders from the ribbon cables pins
• Using a bread-board connect the cables pins of one cable to each other of another (like 1 to 1, 2->2, 3->3, etc. The 1st pin is the far one from the blue pin, and the blue one is the ground)
• Connect the ribbon cables to the Bus A and Bus B connectors on the device
• Go to the Logic Analyzer tab
• Click G-button at the right bottom corner
• Using the mouse create the signals on the Bus B. Use left-click to set "1" and right-click to set "0" on the lines
• Click Run
• At the Bus A you should see the signals generated on the bus B